Publicidad
Idiomas disponibles
Idiomas disponibles
GB | Replacement Button
Designed for wireless doorchime of type P5727.
Specifications
Transmission range: up to 150 m in an open area (can drop down
to one fifth in a busy area)
Button: water resistant; enclosure rating IP44
Pairing of chime with buttons: self-learning function
Button power supply: 1× 3 V battery (type CR2032)
Includes: double-sided adhesive tape
Button Description
(see Fig. 1)
A – battery
B – ring button (button LED)
Removing the Button's Battery Cover
(see Fig. 2)
Chime Description
(see Fig. 3)
1 – ringtone change button
2 – volume setting button
3 – pairing button
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver
into the hole on the side. Insert a 3 V battery, type CR2032,
into the button. When inserting a battery, make sure it has the
correct polarity!
2. Plug the chime into a socket and long-press the pairing button
on the chime for ca 5 seconds.
3. The chime will ring 2 times and will automatically switch to
self-learning mode for 30 seconds. Press the ring button within
30 seconds. The chime will ring once again. The button is now
paired with the chime.
4. Re-assemble the button.
5. To pair multiple buttons, repeat the procedure for each button
from step 1.
3
Publicidad
