Publicidad
Idiomas disponibles
Idiomas disponibles
-
recalls information on the current video page to
the screen. If an error message is displayed, the
first piece of information displayed refers to the
error list. The instructions called up by this icon
integrate (but do not replace) this User Manual.
2.
Automatic dimensions button
-
This enables automatic dimension measure-
ment after which the icon is disabled at the
end of the balancing cycle (ie. dimension
reading is not repeated until the button is
re-enabled).
-
This displays the page for manual entry of
dimensions if the laser sensors have been
disabled (see the "Wheel balancer parameter
configuration" section).
3.
Utility and configuration menu button
-
This groups all the machine Utility and Con-
figuration programmes.
4.
Live button
-
This is used to check and/or modify the balanc-
ing planes measured by the processing unit.
When the machine is switched on, the button
is NOT present as a spin must be performed
with dimension acquisition enabled;
5.
Start button
-
This starts the unbalance measurement cycle
when the guard is lowered.
6.
Stop button
-
This stops the wheel for 50 seconds to allow
wheel mounting/demounting or weight ap-
plication.
-
Interrupts the unbalance measuring cycle.
EM9980 TouchlessLine - Operator's manual
SECONDARY CONTROL
KEYPAD
The secondary control keypad can be used to
quickly modify machine status and consists of
the following five buttons:
1.
enables/disables the Weight Management
suite:
-
Select this button to activate the Less Weight
programme for weight saving consisting of two
balancing modes:
optimised mode for fast vehicle
wheels;
or
optimised mode for slow vehicle
wheels;
press the button again to deactivate the
Weight Management suite.
Wheel balancing is performed using the de-
sired balancing programme. At the end of the
spin, if wheel balancing is considered satisfac-
tory, the position indicators will display the
icons
and two semicircular indicators
for indicating the residual rotation torque
unbalance level (left indicator) and static
rotation torque level (right indicator).
2.
selects the required operator:
-
This button can be used to change operator
quickly.
-
3 operators can be selected (1, 2 or 3) and
named (see the "Customisation" section).
-
When a new operator is selected, the machine
resets the parameters that were active at the
last recall.
The stored parameters are:
-
Balancing mode; Dynamic, ALU, etc...
-
Wheel dimensions.
-
Last phase of OPT.
-
General machine settings: grams/ounces,
sensitivity x5/x1, etc...
UK
53
Publicidad
