Corghi EM9980 TouchlessLine Manual De Uso página 57

and wait until the wheel stops before raising
the guard.
- Wait for the wheel to stop automatically and
the image shown in figure 14 to be displayed
showing the automatically recognised edge
and indicated by the laser point of the internal
sensor on the rim.
If the selected balancing programme requires
the application of a spring weight on the inner
side, the laser point must correspond with the
rim edge (figure 15).
Position 1 spring weight
If the selected balancing programme requires
the application of an adhesive weight on the
inner side, the laser point must correspond
with the application plane of the adhesive
weight. Please remember that the laser point
indicates the centre of the weight (figure 15a).
Position 2 adhesive weight
If the suggested application position is correct,
proceed as follows:
EM9980 TouchlessLine - Operator's manual
- press and release the LIVE
located on the weight tray (see figure 15b);
If the suggested application position is not
correct, proceed as follows:
15 - press (and hold) the LIVE
- turn the wheel clockwise to move the laser
triangulator forwards or anti-clockwise to move
it backwards;
- release the LIVE
the position
- if the ALU1 or ALU2 balancing programme is
selected, the machine will request confirma-
tion for both positions. Position 1 is indicated
in figure 15 (for a spring weight, i.e. ALU2) and
figure 15a (for an adhesive weight, i.e. ALU1)
whereas position 2 is indicated in figure 15c.
15a
Position 2
- after confirmation, the machine will automati-
button
15b
button;
button to confirm
UK
15c
57