SICK G6L Instrucciones De Operación página 8

OPERATING INSTRUCTION
4 Mounting
en
5 Electrical installation
8 O P E R A T I N G I N S T R U C T I O N | GSE6L
3
2 3
Mount sensors (sender and receiver) using suitable mounting brackets (see the SICK
range of accessories). Align the sender and receiver with each other.
NOTE
When mounting through beam photoelectric sensors adjacent to each other, alternate
the sender (GS6L) and receiver (GE6L) arrangement every other pair. Also ensure
that there is sufficient distance between pairs based on the sender (GS6L) light spot
diameter. Refer to figure 2 and
Sender (GS)
Receiver (GE)
Sender (GS)
Figure 2: Arrangement of several through-beam photoelectric sensors
Diameter in mm (inch)
Ø 3.5 Ø 70 Ø 90 Ø 120
(0.14) (2.76) (3.54) (4.72)
1 12 30 40
(3.28) (39.37) (98.43) (131.23)
Distance in m (feet)
Figure 3: GSE6L
The sensors must be connected in a voltage-free state (U
tion must be observed depending on the connection type:
2
figure 3.
V
Receiver (GE)
Sender (GS)
Receiver (GE)
= 0 V). The following informa‐
8025390.1CGF/2021-07-13 | SICK
Subject to change without notice