Operation; Before First Use; Switching On; Switching Off - Gaggenau VP 414 Instrucciones De Uso

Operation

Before first use

Please observe the following notes before frying on
your new appliance for the first time:
1 Thoroughly clean the appliance and accessories.
2 Heat up the appliance to 200°C for a few minutes.
This will eliminate any 'newness' smells and soiling.

Switching on

Press down the temperature control knob and turn it left
or right to the required temperature between 120 ­
240°C.
It is possible to switch on only the front or rear frying
zone with the left control knob if you do not want to use
the whole frying surface. Press down the left control
knob and select the required frying zone
The luminous disc behind the temperature control knob
flashes. When the temperature is reached, the luminous
disc lights constantly.
After heating up, coat the frying surface with a little oil
or fat with the spatula or a heat-resistant brush (e.g. a
silicone brush). Put the food directly – without pots or
pans – on the frying surface. Use the included spatulas
to turn the food.

Switching off

Turn the control knob to 0.
m
Risk of burns!
When the appliance cover is closed, heat will
accumulate. Only close the appliance cover when the
appliance has cooled down. Never switch the appliance
on with the appliance cover closed. Do not rest food on
the appliance cover or use it to keep food warm.

Residual heat indicator

The luminous disc behind the right control knob flashes
after switching off, to indicate that the appliance has
still not cooled down to such an extent that it can be
touched safely.
8

Keeping warm setting

The keeping warm level enables you to keep food warm
after frying.
Turn the temperature control knob to the keeping warm
setting
frying surface or only the front or rear frying zone.

Safety shut-off

For your protection the appliance features safety shut-
off. Every heating operation is switched off after four
hours if the appliance is not operated during this time or
after a power cut. The luminous disc behind the
temperature control knob flashes.
Turn the temperature control knob to 0. Then you can
operate the appliance again normally.
Q R
or .
£
. Use the left control knob to select the whole