Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION (FIG.3)
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly
fixed to avoid vibration and slipping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10 times of the unit's weight.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety rope. Never stand directly below the device when mounting, removing or servicing the fix-
ture. This fixture may be mounted in any position provided there is adequate room for ventilation.
When mounting this fixture on a truss, be sure to use an appropriate clamp. As an added safety
measure, be sure to attach at least one properly rated safety cable to the fixture.
POWER LINK
Connect an POWERCON cable from the POWER OUT connector of the 1st unit to the POWER IN
connector of the second unit, etc.
CONTROL PANEL (FIG. 2)
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach
function you wish to change. When you reach the function you wish to change, press the ENTER
button. When a function is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button.
Check the following function table :
MENU
ADDR
MODE
AUTO
SOUN
MIC
LOAD
VER
SET
CALI
FREQ
CH07
DMX
CH15
REST
ON/OFF
WXXX
MANU
CXXX
TEMP
TXXX
DMX channel chart: please refer to page 3-4
IR REMOTE CONTROLLER
Please operate the remote control within a distance of 6m and 30° between the remote and the
appliance. Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
The remote control might not work properly if the sensor is exposed to strong sunshine.
If the remote control doesn't work properly, please check the batteries.
EN
6
VALU
A001~A XXX (AXXX)
SLAV
ALON /(AU-A)
IP1-15
MAST /AU-M)
IP1-5
M-XX
ON/OFF
V-2.0
Code (password: 088)
CH03-CH04
Low/High
C000-255
C000-255
SP_1~SP_5 (Speed) Auto-run (Master)
ALON (SO-A)
MAST/(SO-M)
DESCRIPTION
DMX address setting
Slave setting
Sound control (alone)
Sound control (Master)
Mic sensitivity setting
Reload data
Software version
Input password
Calibration
PWM Frequency setting
7CH
15CH
Reset to factory default
Warm dimmer
Cold dimmer
Current temperature
© Copyright LOTRONIC 2022
Publicidad
