Vaisala HUMICAP HMT130 Guía Rápida página 13

__________________________________________________________________________ English
Troubleshooting
Technical Support
Product Returns
VAISALA _______________________________________________________________________ 11
Error Codes and Texts
Code Description
1 Probe T measurement error
2 Probe RH measurement error
3 Probe communication error
4 Probe checksum error
5 Probe message form error
6 Program's flash checksum error
7 Current settings checksum error
(RAM)
8 Factory flash not initialized
9 User flash not initialized
10 Voltage is too low to operate
correctly
11 Measurements not available
12 Oscillator fault bit active
13 Analog output quantity invalid
14 Display quantity invalid
15 Invalid quantity selected for relay
The complete HMT130 User's Guide is available in English at
www.vaisala.com/hmt130.
For technical questions, contact the Vaisala technical support by e-mail at
helpdesk@vaisala.com. Provide at least the following supporting
information:
- Name and model of the product in question.
- Serial number of the product.
- Name and location of the installation site.
- Name and contact information of a technically competent person who
can provide further information on the problem.
If the product must be returned for service, see www.vaisala.com/returns.
For contact information of Vaisala Service Centers, see
www.vaisala.com/servicecenters.
Error Text
Probe T meas
Probe RH meas
Probe communication
Probe checksum
Probe message form
Program code checksum
Settings checksum
Factory defaults empty
User defaults empty
Voltage too low
Measurements not available
HW fault 1
Analog output quantity invalid
Display quantity invalid
Relay quantity invalid