Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
WARNING
WARNING
resulting in possible serious injury.
WARNING
recommended can result in serious personal injury.
1. Turn the wheel by hand to make sure it does not touch the guard, eye shields, spark
deflectors or wheel rests and runs freely.
2. Stand to one side, turn the switch on and allow the motor to reach full speed.
3. Support the workpiece on the work rest and gradually feed the workpiece into the wheel.
Use pliers to hold small workpieces.
NOTE: Traverse the workpiece across the full width of the wheel to prolong its flat surface.
4. If the grinding operation causes the motor speed to noticeably decrease, pull back the
workpiece, allow the motor to regain full speed and restart the grinding operation, but
apply less force.
On/Off switch (Fig . 9)
To start grinder: press the switch to "1"
•
position.
To turn the grinder off: press the switch to
•
"0" position.
If the grinder does not immediately start,
switch the grinder off, disconnect the power
cord and check voltage at power source.
18
To reduce the risk of injury, no adjustments to wheel rests, spark shields or
other components should be made while the grinder wheels are turning.
Always wear eye protection with side shields marked to comply with ANSI
Z87.1. Failure to do so could result in objects being thrown into your eyes
Do not use any attachments or accessories not recommended by the
manufacturer of this tool. The use of attachments or accessories not
Fig . 9
Publicidad
