Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Problem
Grinder will not start.
Wheel does not
come up to speed.
Excessive vibration
Cause
1. Power cord is not plugged
in.
2. Fuse or circuit breaker is
tripped.
3. Cord is damaged.
4. Burned out switch.
1. Extension cord is too light
or too long.
2. Low supply voltage.
1. Grinding wheel is not fixed
properly.
2. Bench grinder is not
mounted securely to the
stand or workbench.
Remedy
1. Plug power cord into a
functioning power outlet.
2. Replace fuse or reset a
tripped circuit breaker.
3. Have cord replaced by an
authorized SKIL service
center or service station.
4. Have switch replaced by
an authorized SKIL service
center or service station.
1. Replace with an adequate
cord.
2. Contact your electric
company.
1. Re-install grinding wheel
following the section "WHEEL
REPLACEMENT" in this
manual.
2. Tighten all mounting
hardware.
23
Publicidad
