Descargar Imprimir esta página

Project Source ETHAN 21-K121HCP-PS Manual Del Usuario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valves under the sink or at the
main water supply. Disconnect the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area where the new faucet will be
mounted.
2.
Before installation, unscrew the quick-connector (2.1) from the
end of the spray hose (2.2) by turning it in a counterclockwise
direction. Remove the preassembled lock nut (CC), rubber
washer (AA), and metal washer (BB) from the shank (2.3) on
the faucet body (A).
3.
To install with the optional deckplate for a 3-hole sink, skip to
Step 4.
Before installation, make sure the flange (3.1) is on the bottom
of the faucet body (A). Pull the spray hose (3.2) up through the
faucet body (A) until the end of the hose is flush with the bottom
of the shank (3.3) on the faucet body (A). Do not pull the fitting
on the bottom of the spray hose (3.2) past the shank. Carefully
insert the water lines and tubes (3.4) on the faucet body (A)
through the mounting hole in the sink (3.5). Skip to Step 5.
NOTE: Do not feed the spray hose (3.2) back down through the
faucet body (A) until Step 6.
4.
OPTIONAL DECKPLATE INSTALLATION:
The optional deckplate (B) and gasket (C) cannot be installed
with the flange (see 3.1 above) on the bottom of the faucet body
(A). Apply a thin bead of silicone to the underside of the gasket
(C). Place the gasket (C) and deckplate (B) over the mounting
holes in the sink, aligning the center holes in the gasket (C) and
deckplate (B) with the center mounting hole in the sink (4.1).
Pull the spray hose (4.2) up through the faucet body (A) until the
end of the hose is flush with the bottom of the shank (4.3) on
the faucet body (A). Do not pull the fitting on the bottom of the
spray hose (4.2) past the shank. Carefully insert the water lines
and tubes (4.4) on the faucet body (A) through the hole in the
deckplate (B) and the mounting hole in the sink (4.1) until the
faucet sits on top of the deckplate (B).
NOTE: Do not feed the spray hose (4.2) back down through the
faucet body (A) until Step 6.
4
1
2
AA
BB
CC
2.2
2.1
3
3.2
3.1
3.5
4
4.2
4.3
4.1
2.3
A
3.3
3.4
A
4.4
B
C

Publicidad

loading

Este manual también es adecuado para:

Ethan 21-k121hss-psEthan 21-k121hmb-ps251706629168472916848