Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (Continued)
5.
From underneath the sink, secure the faucet body (A) to the
sink using the rubber washer (BB), metal washer (AA), and
lock nut (CC). Secure the lock nut (CC) with the hex bolts (5.1).
NOTE: It is helpful to have a second person hold the faucet in
place while tightening the bolts on the lock nut.
Hardware used
AA
Metal Washer
BB
Rubber Washer
CC
Lock Nut
6.
Feed the spray hose (6.1) back down through the spout (6.2)
and faucet body (A) and through the hole in the sink. Loosen
the cover on the weight (D) and slide it onto the spray hose
(6.1) until it is positioned at the location marked "weight
here," then hand tighten the cover by turning it in a clockwise
direction. Confirm the O-ring at the end of the spray hose (6.1)
is positioned correctly. Reattach the quick-connector (6.3) by
pushing it onto the end of the spray hose (6.1).
7.
Confirm the O-ring on the receiving block (7.1) is positioned
correctly. Attach the quick-connector (7.2) to the receiving block
(7.1) by pushing it firmly upward. Pull down gently to ensure the
connection is secure. If necessary to detach the quick-connector
(7.2), push up on the quick-connector (7.2) and hold the locking
mechanism down firmly, then pull down on the quick-connect
(7.2) to disconnect.
8.
Attach one end of each of the water supply lines onto the
shanks (8.1) on the faucet body (A), with hot water on the left
and cold water on the right. Use 1/2 in. IPS faucet connections
(8.2) or supply line coupling nuts (8.3) with 3/8 in. OD ball-nose
risers (8.4).
NOTE: Do not reuse existing supply lines. When installing new
water supply lines, please refer to the supply line manufacturer's
installation instructions.
Tighten the supply line connections using two wrenches. Place
the first wrench on the shank on the tube (8.1) to hold it in
place while tightening the supply line with the second wrench.
This will help prevent twisting of the tubing. Do not overtighten.
Repeat for the second tube and supply line. Use caution when
tightening the connections, as the lines can crimp or break,
causing a leak.
x 1
x 1
x 1
10. 1
A
5
5
A
BB
AA
CC
5.1
6
6.2
D
6.1
6.3
7
7.2
7.4
8
8.1
8.4
8.3
8.2
7.1
7.3
Publicidad
