Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.
TROUBLESHOOTING
If a faucet installation doesn't deliver water properly or leaks, finding the cause and fixing it can be easy.
PROBLEM
POSSIBLE CAUSE
Faucet leaks
Bonnet has come loose or the
underneath handle.
ceramic cartridge seal is dirty
or out of place.
Water does not
Ceramic cartridge discs are
completely shut off.
worn or have debris trapped
inside.
Faucet leaks around
The aerator is incorrectly fitted,
aerator.
dirty, or small parts inside
the aerator are improperly
installed.
Faucet has an
The aerator is dirty or small
improper water
parts inside the aerator are
pattern.
improperly installed.
No water pressure or
The connector is blocked.
low water pressure
after a longer period
of use.
ROUGH-IN
SOLUTION
1. Move the handle to the OFF position. Unscrew the handle screw and remove the
handle.
2. Tighten the bonnet by turning it clockwise. Move the cartridge stem to the ON position.
The leak should stop draining out from around the cartridge stem.
3. If the leak does not stop, shut off the water supply. Remove the bonnet by turning it
counterclockwise. Lift out the ceramic cartridge. Inspect the seal on the bottom of the
ceramic cartridge. Remove any debris from the seal. If the ceramic cartridge seal is
twisted or out of place, re-seat it. If the ceramic cartridge seal is worn or damaged,
replace the cartridge by calling customer service.
4. Position the cartridge back into the faucet body. Make sure the ridges on the two sides
of the cartridge bonnet fit into the grooves on the two sides of the faucet body. Tightly
screw the bonnet onto the faucet body.
5. Reinstall the handle.
1. Shut off the water supply.
2. Move the handle to the OFF position. Unscrew the handle screw and remove the
handle.
3. Remove the bonnet. Lift out the ceramic cartridge.
4. Position the new ceramic cartridge into the faucet body.
5. Tightly screw the bonnet into the faucet body.
6. Reinstall the handle.
1. Remove the aerator from the spout on the faucet body. Inspect the black rubber gasket
inside the aerator. The rubber gasket should be flat.
2. Reinstall the aerator on the spout.
1. Remove the aerator from the spout on the faucet body.
2. Gently flush the small parts inside the aerator to clear away any debris.
3. Reinstall the aerator on the spout.
1. Remove the spray head by unscrewing it from the hose assembly in a counterclockwise
direction.
2. Hold the end of the hose assembly down into the sink and turn the faucet on to the
warm position where it mixes the hot and cold water. If the water flow is still slow or
completely blocked, please call customer service.
7
Publicidad
