Bosch VLS 3132 H Manual Original página 25

5.2 Authorized users
Only users aged 18 or above who have been instructed
on how to operate the lifting platform and have proven
their ability to do so to the owner are to be entrusted
with unsupervised operation of lifting platforms. The
task of operating the lifting platform must be expressly
assigned to users by the owner. Authorization to opera-
te lifting platforms must be granted in writing.
Before loading a vehicle onto the lifting platform, users
should study the original operating instructions and
familiarize themselves with the operating procedures in
several trial runs.
5.3 Preparation by the user
5.3.1 Space requirements
Refer to Appendix A for the dimensions of the lifting
platform.
There must also be a clearance of at least 1 meter bet-
ween the lifting platform and fixed elements (e.g. wall)
in all lifting positions.
There must be sufficient space at the ends of the lifting
platform for driving vehicles on and off.
i
To stop vehicles colliding with the ceiling, it is ad-
visable to fit an overhead light barrier in low-ceilin-
ged buildings.
5.3.2 Foundation and connections
The user must have the following work performed befo-
re erecting the platform:
R
Construction of the foundation following consulta-
tion with Bosch customer service or an autho-
rized service agent.
R
Routing of the wiring to the installation location. The
user must provide fuse protection for the connec-
tion.
R
Routing of the compressed air connection to the
installation location. The user must install a service
unit upstream of the connection.
i
Refer also to the corresponding information in the
commissioning instructions.
Robert Bosch GmbH
Product description | VLS 3132 H | 25
5.4 Transportation information
The lifting platform is delivered as follows:
Packing unit Dimensions
1 x crate 1660 x 680 x 790 mm
(5.5 x 2.3 x 2.6 feet)
The user must provide a forklift truck for internal
transport. The center of gravity and lashing points are
marked on the packaging.
Fig. 1: Center of gravity of packaging (example)
5.5 Set-up and initial commissioning
The lifting platform is only to be started up by Bosch
customer service or an authorized service agent. Initial
commissioning of the lifting platform is described in the
installation instructions. Acceptance must be performed
by a qualified person after initial commissioning.
5.6 Scope of delivery
Description
Lifting platform VLS 3132 H, complete
20 mm elastomer retainers (x 4)
Original instructions
Test log book
5.7 Special accessories
Information on special accessories (e.g. overhead light
barrier, turntables, alternative longer drive-on ramp,
additional drive-off ramp) can be obtained from your
Bosch franchized dealer.
en
Weight
750 kg
(1654 lb)
Order no.
1 692 852 321
1 692 872 361
1 689 989 107
1 689 977 092
|
1 689 989 107 2012-09-10