Publicidad
Idiomas disponibles
Idiomas disponibles
Lifting and transporting the work vehicle
The lifting procedure shown applies for all the work ve-
hicle models specified in the manual.
For models BABY COMPACT/3 and BABY COMPACT/5
the seat must be removed to allow the lifting means to
be fitted.
D
C
B
UN41 0064CF
Proceed as outlined below.
1) Use the specific tool (A) provided with the work vehi-
cle for lifting.
2) Strap up the work vehicle as shown in the figure.
3) Check that the pin (B) is secured by the lock pin (C)
and that the chains are fastened stably to the frame.
Loading, transporting and unloading the work vehicle / tractor assembly
The transportation of the work vehicle / tractor assembly
must be carried out using appropriate means of trans-
port equipped with suitable ramps.
Proceed as outlined below.
1) Start the tractor and lift the work vehicle as far off the
ground as is permitted.
English language
SAFETY INFORMATION CONCERNING HANDLING AND
INSTALLATION
11
The illustration shows the work vehicle with two plant-
ing units.
A
4) Lift the work vehicle and place it on the means of
transport.
5) Anchor the work vehicle to the means of transport
with wedges and ropes.
2) Get into the means of transport from the tractor's
driving seat.
3) Lower the work vehicle onto the truck bed.
4) Anchor the work vehicle / tractor assembly to the
means of transport with wedges and ropes.
4
D
Use and maintenance
Publicidad
