Publicidad
Idiomas disponibles
Idiomas disponibles
Adjusting the dispensing / ejection timing
When the plant falls into the ploughshare (C), the ejector
(B) should be in the rear position and should then start
pushing the plant to eject it.
A
UN41 0050CF
Proceed as outlined below.
1) Loosen the screws (A).
2) Turn the dispenser clockwise to speed up the ejec-
tor's pushing action or rotate the dispenser anticlock-
wise to delay the pushing action.
English language
ADJUSTMENT INFORMATION
If the conditions allow high- or low-speed planting, cor-
rect timing between the dispenser and the ejector can
be maintained by adjusting the dispenser.
The notches on the dispenser allow accurate timing
adjustment.
3) Tighten the screws (A).
14
5
C
B
Use and maintenance
Publicidad
