Publicidad
Idiomas disponibles
Idiomas disponibles
SilverCrest SMA 500 E1
7. Initial use
Before you prepare milk for consumption for the first time, you must first clean the milk frother in
order to remove dust and any remnants of the packaging material. Follow the procedure described
in the 'Maintenance/cleaning' section.
DANGER of electric shock
Keep the base (10) away from water. There is danger of electric shock.
WARNING – Risk of burns
Only operate the milk frother with the lid (2) on.
The surface of the heating element is still hot after use.
WARNING – Risk of injury
Always use fresh milk. Do not consume milk that has been sitting in the canister (6) for
a long period of time.
Please note:
If you lift the canister (6) off the base (10) during operation, the preparation process
stops automatically. Place the canister (6) onto the base (10) again and restart the
process using the button (8).
Cable rewind
A built-in cable rewind is located on the
bottom of the base (10). You can adapt
the length of the power cable (11) to the
conditions at your location.
You can minimise the length of the cable
when you are not using the milk frother.
•
Unwind the power cable (11) on the underside of the base (10) against the direction of the
arrow.
•
Place the base (10) on a flat, non-slip and dry surface. Make sure that the power cable (11)
passes through the opening on the underside of the base (10). This is to ensure that the milk
frother is positioned securely.
WARNING
If the power cable (11) does not pass through the opening on the underside of
the base (10), the base (10) and canister (6) are not positioned securely.
34 - English
Publicidad
