Publicidad
Idiomas disponibles
Idiomas disponibles
SilverCrest SMA 500 E1
You can stop the preparation process at any time by briefly pressing the button (8).
•
Wait around 30 seconds until any remaining fluid milk settles at the bottom of the canister (6).
•
Lift the canister (6) off the base (10), remove the lid (2) and use the milk froth as you wish.
7.8 Heating milk evenly
•
Insert whisk (4) up to the stop on the drive shaft inside the canister (6).
•
Take the canister (6) off the base (10) and pour milk up to the MIN marking inside the canister
(6). Only pour milk up to the upper MAX marking in order to prevent the hot milk from
overflowing.
•
Place the lid (2) onto the canister (6).
•
Place the canister (6) onto the base (10).
•
Use the button (8) to select operating mode 3. The symbol of the operating mode 3 (7) flashes
and after approximately three seconds the whisk (4) begins to turn, thus ensuring even heating.
•
As soon as the milk is hot, the milk frother automatically switches off and the symbol of the
selected operating mode (7) flashes; it then goes out again after a short time.
You can stop the preparation process at any time by briefly pressing the button (8).
•
Lift the canister (6) off the base (10), remove the lid (2) and use the hot milk as you wish.
•
Wait two to three minutes before using the milk frother again.
38 - English
Publicidad
