TECNOMOTOR 820 Manual Operativo página 64

message is timed. Press key to move 
faster to the next phase.
At the end of the measurement, the detected peak
value is displayed. Press ESC to end
measurement.
11.3 Automatic zeroing
Procedure starts from the free page..
Press F key.
Select the item referred to automatic zeroing.
Confirm using the key ().
Cell zeroing procedure is automatically performed.
11.4 Rpm division
This function is used to set the correct multiplication or division factor for the type of vehicle being
tested.
Procedure starts from the free page.
Press F key.
Select the item referred to rpm division.
Confirm using the key ( ).
If the revolution counter is connected the
calculated rpm is displayed using the set divisor.
Press the up arrow or down arrow keys to
modify the divisor.Confirm using the key ( ).
().
11.5 Printing the opacimeter free page
It is possible to print the values displayed in the free page. Procedure starts from this page.
Press F key.
Select the item referred to print and press .
OPACITY PEAK VALUE
1.23 [1/m]
Free Acceleration
►Automatic zeroing
Rpm division
Free Acceleration
Automatic zeroing
►Rpm division
...
RPM=1020 RPM
Divide by: 1
Free acceleration
Automatic zeroing
Rpm division
►Print
26
Accelerata libera