Product Installation; Power Supply - TECNOMOTOR 810 Manual Operativo

Caution
This guide was created with the aim to guide the user to a correct installation
of the product in a few steps and to a first gas analysis of the vehicle.
For further information and purely technical issues, please refer to the user
manual 1161061-0 contained in the supplied CD, where you can learn
more about the topics covered in this quick guide.

2 Product installation

Remove the instrument from its packaging and carry out the procedure
for the first analysis of the exhaust gases of a vehicle in 10 minutes.

2.1 Power supply

The device is powered through the network cable present inside the package.
Insert the power cable inside the socket located at the back of the instrument,
as shown in the figure.
Turn the instrument on by pressing the button next to the power socket.
5