TECNOMOTOR 810 Manual Operativo página 87

To ensure operator's safety, before carrying out any test,
1. Check the fitting of any accessories to adapt the front wheel locking device
and, if necessary, remove them in case of wheels with pronounced
curvatures or particularly low alloy wheels.
2. Bring the vehicle to the speed test bench by positioning the rear wheel on
the rollers.
3. Close the front wheel clamp until the vehicle is securely locked.
To ensure operator's safety, before carrying out any test,
make sure you have correctly locked the vehicle on the
Constantly check the good stability and effectiveness of
4. Position the cooling fans in front of the engine or radiator of the vehicle at a
suitable distance so that the cooling air is effective.
5. Position any exhaust gas intake devices.
NOTE: If the switching on of the cooling fan and the exhauster are automated,
the program will automatically start them during the test run.
6. Start the vehicle.
7. Gradually increase the speed of the vehicle by acting on the accelerator,
until the maximum knob travel is reached.
8. Observe the parameters of interest on the display device.
9. Hold the knob position until the speed is stabilised or until the test is
deemed complete.
The user is guided through appropriate on-screen
messages during the entire procedure. It is therefore
important to pay the utmost attention to the messages
displayed as they contain basic instructions for
make sure you have correctly locked the vehicle on the
roller by acting on the clamp closure.
rollers by acting on the clamp closure.
the vehicle's locking system on the roller bench
throughout the test period.
WARNING!
performing the tests.
WARNING!
WARNING!
WARNING!
33