Publicidad
Idiomas disponibles
Idiomas disponibles
Welcome screen with
post-processing option
enabled
Job Mode screen
5. Logging new GPS/GIS Data Using
the "Post-Processing" Job Mode
Notice: The Post-Processing job mode option is available only
in receivers upgraded to record data for post-processed differ-
ential correction. You may skip the reading of chapter 5 if your
receiver has not been upgraded to use this option. For more
information on the Post-Processing option, please refer to the
User Manual delivered on CD.
Creating a Job with the Post-Processing Option
- If there is a job that is currently open, close it by pressing
MENU and selecting Close Job
- Press LOG. MobileMapper Pro displays the Welcome
screen. This screen shows three options (instead of the
two that you can see on a MobileMapper Pro without the
post-procesing option being enabled).
- Highlight Create New Job and press ENTER.
- Enter the job name as explained earlier (see page 6).
- After entering the name, highlight the OK key on the
screen and press ENTER. A new screen is then displayed
listing the feature libraries stored in MobileMapper Pro.
- Highlight the library you want to use and press ENTER. A
new screen is then displayed asking you to choose the job
mode:
• Real-time: If you select this job mode, MobileMapper
Pro will record the job as if there were no post-process-
ing option enabled in the receiver
• Post-processing: Select this job mode to allow
MobileMapper Pro to record the job so that later on, it
can be post-processed in MobileMapper Office. By
selecting this job mode, you allow MobileMapper Pro
to record a GPS measurements file in addition to the
"usual" MMJ job file.
17
Publicidad
