Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. Repeat the above step until you can hear the line-cutting
noise.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
Do not pull or release the trigger too fast.
It will damage the machine if you hit the head to try to
advance the line.
9.4
ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
Figure 7.
1. Stop the machine.
2. Push the spool retainer button and pull on cutting line to
manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it again.
9.5
CHANGE TO THE EDGING MODE
Figure 8.
You can change the machine to a well groomed edger for
edging patios, driveways and walkways or other areas.
1. Stop the machine.
2. Push on the edge button and turn the trimmer head 90
degrees until the trimmer head locks into position.
3. Release the edge button.
9.6
PIVOTING HEAD FUNCTION
Figure 9.
Adjust pivoting head to trim areas which are hard to reach
and for users to operate comfortably.
1. Stop the machine.
2. Push on the pivoting button and turn the shaft until the
trimmer head locks into required position.
3. Release the pivoting button.
9.7
OPERATION TIPS
Figure 11.
NOTE
NOTE
NOTE
NOTE
NOTE
English
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Do these tips when you use the machine
•
Keep the machine connected to the correctly worn
harness.
•
Keep a firm hold with the two hands on the machine
while you operate the machine.
•
Cut tall grass from the top down.
If grass winds around the trimmer head:
•
Remove the battery pack.
•
Remove the grass.
9.8
CUTTING TIPS
Figure 10.
•
Tilt the machine toward the area to be cut. Use the tip of
the cutting line to cut grass.
•
Move the machine from right to left to prevent thrown
debris toward the operator.
•
Do not cut in the dangerous area.
•
Do not force the trimmer head into uncut grass.
•
Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
10
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Examine
regularly that you install the handles tightly.
Use only the replacement parts and accessories of the initial
manufacturer.
10.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
8
WARNING
WARNING
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
Publicidad
