Operation; Important; Start The Machine; Stop The Machine - GreenWorks STB80L01 Manual Del Operador

1
9

OPERATION

IMPORTANT

Before you operate the machine, read and
understand the safety regulations and the operation
instructions.
WARNING
Be careful when you operate the machine and
always observe your surroundings before operating
tool.
9.1

START THE MACHINE

1. Push the lock-out button (1) and pull the trigger
(2).
1
B
A
2. Push the speed switch (3) to the desired
operating speed. Push the speed switch to
position A for low speed or position B for high
speed.
9.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
English
2
3
9
9.3 ADJUST THE LENGTH OF THE CUTTING
LINE
While you operate the machine, the cutting line gets
worn shorter. You can adjust the length of the cutting
line.
1. While the trimmer is running, bump the trimmer
head against the ground.
2. Line is automatically released and the cut-off
blade cuts the excess length.
9.4

ADJUST THE CUTTING DIAMETER

The machine is set at a 14 in. (35.6 cm) cutting
diameter. You can adjust to a 16 in. (40.6 cm) cutting
diameter.
Set the cutting diameter to 14 in. (35.6 cm) for
greater runtime and 16 in. (40.6 cm)for a larger
cutting area.
1. Remove the battery pack.
2. Remove the blade screws from the cut-off blade.
3. Turn the cut-off blade 180°.
4. Tighten the blade screws.
NOTE
EN