Publicidad
Idiomas disponibles
Idiomas disponibles
• Read the instructions carefully. Operators should be familiar with the controls and the proper
use of the equipment.
• Always use the trimmer with the guard (protective skirt). The guard is a safety device for the
operator. Mounted on the guard is the cutting blade that limits the length of the nylon string and
prevents the overloading and consequent burnout of the engine.
• The use of the equipment without the guard, or with a nylon string that exceeds the recommended
diameter, will void the warranty.
• Before turning on the equipment, check if the trimmer's electrical voltage is set in accordance
with the local electrical voltage.
Guard - Fig. 01, page 03
Mount the guard (2) on the body (1) by fitting the three pins on the body into the notches on the guard
and attaching it with the three screws (3).
Handle - Fig. 02, page 03
Attach the handle (4) to the grip (5), with its curvature as pictured. Adjust to the desired angle and
insert the bolt (6) in the handle (4). Attach the knob (7) on the other side and tighten until secured. The
bolt may be fitted on either the left or right side.
Handle adjustment - Fig. 02 and 03, page 03
To adjust the position of the handle (4), loosen the knob (7), set to the desired position, and tighten
the knob (7) again.
Using the equipment without the guard (protective skirt) will void the warranty.
Before using the equipment, read carefully the user and maintenance manual.
Before turning on the equipment, check if the trimmer's electrical voltage is set in accordance with the
local electrical voltage.
For your safety and to prevent the electric cable from being disconnected from the plug during its use,
bend the cable (1) and pass it through the opening (2), [Fig. 04, page 04], then fit it in the clamp (3),
[Fig. 05, page 04], only then connect the electric cable to the plug of the grass trimmer.
The trimmer must be used with both hands. Secure the grip with one hand and the handle with the other.
Keep the switch pressed down constantly while operating, and avoid oscillations in the rotation of the engine.
To turn off the trimmer, just release the switch.
WARNING
EQUIPMENT ASSEMBLY
OPERATION AND USE
EN
12
Publicidad
