Publicidad
Idiomas disponibles
Idiomas disponibles
2.2.3 Display mode setting
I t is possible to set what should be shown on the display when the latter is in standby mode
a) Use the arrow keys
b) Select the password "7" with the
c) Scroll with the
key and select the submenu [12] and confirm with the
d) Using the keys
and
"OFF"
•
"1"
•
"2"
•
"3"
•
•
"4"
e) Press the key
to confirm the set data.
2.2.4 Volume setting
S et the volume level of the buzzer, according to your requirements:
a) Use the arrow keys
b) Select the password "7" with the
c) Scroll with the
key and select the submenu [13] and confirm with the
d) Use the
and
keys to set the desired volume level (OFF,1 ... 5) and confirm with the
2.2.5 Fuel optimisation
Excellent fuel depends on different factors (type of installation, operating and maintenance conditions,
type of pellets, etc.)
Generally speaking, if at the end of combustion, there is a lot of residue in the burn pot, you should change
the combustion configuration (by increasing the value) until you find the best solution.
a) Use the arrow keys
b) Select the password "7" with the
c) Scroll with the
key and select the submenu [14] and confirm with the
d) Set with the keys
" 1"
"2"
"3"
e) Press the key
to confirm the set data.
20
to go to the set-up menu
key and confirm with the
, set one of the following values:
The display will remain fixed on the last display operated by the user;
All the operating parameters will be displayed cyclically;
The temperature is displayed (detected by the room probe)
The current time is displayed
The autonomy is displayed in hours before having to refill the tank, if the refuelling
function has been enabled.
to go to the set-up menu
key and confirm with the
to go to the set-up menu
key and confirm with the
and
one of the following values:
and press the key
;
key;
key;
and press the key
;
key;
key;
and press the key
;
key;
key;
key.
004778440 - 11/01/2022
Publicidad
