Publicidad
Idiomas disponibles
Idiomas disponibles
3.5 Operation with room sensor on stove
The appliance can be switched on/off either manually or according to a program.
The appliance modulates the power according to the room temperature detected by the on-board probe
(i.e. the appliance attempts to maintain the desired temperature while consuming as little as possible).
If the user has enabled "Eco-mode", the appliance switches off, instead of modulating, when the set tem-
perature has been reached and switches on again when the room temperature falls below the set delta.
It is possible to set the desired room temperature in the temperature menu
4
AVAILABLE FUNCTIONS
4.1 Fuel (where included)
Enabling this function allows the appliance to communicate when the pellet hopper status reaches a
level considered low, through visual and acoustic alerts on the display.
Disabling this function on the other hand means the user is forced to personally check the pellet hopper
to determine whether it needs to be filled.
To enable/disable this function:
a) Use the
keys on the ventilation menu
b) Set with the keys
"OFF"
•
•
"ON"
c) Press the key
to confirm the set data.
4.2 Timer
It is possible to set, enable and assign to the various days of the week, customised programs for the
automatic ignition and/or shutdown of the appliance.
Up to six customised programs can be configured.
For each program it is possible to set: start time, switch off time and desired temperature.
Up to three programs can be assigned to each day of the week.
The days of the week are identified by numbers: Monday = "d1", Tuesday = "d2"; ...; Sunday = "d7".
4.2.1 Program settings
a) Use the arrow keys
b) Select the password "7" with the
c) Select the submenu [2] and confirm with the
d) scroll through the programs P1...P6 using the keys
pressing
;
e) The switch-on time will flash; change the value with the
f) The minutes value will flash; change the value with the
g) The value of the switch-off time will flash; change the value with the
key;
h) The minutes value will flash; change the value with the
i) The desired temperature value will flash; change the value with the
j) Press the key
to confirm the set data.
22
and
one of the following values:
Pellet sensor function disabled;
Pellet sensor function enabled. The display will communicate when the pellet
hopper needs to be refilled.
to go to the set-up menu
key and confirm with the
and press the
key;
and press the key
key;
key;
and
, select the value you want to change by
and
keys and press the
and
keys and press the
and
keys and press the
.
;
key;
key;
and
keys and press the
key;
and
keys;
004778440 - 11/01/2022
Publicidad
