Palazzetti DISPLAY BLE Uso Y Funciones página 25

5 ALARM MANAGEMENT
If an anomaly occurs in the operation, the following procedure is activated:
a) acoustic alarm (beep);
b) one of the following status LEDs lights up:
c) if the fault concerns an error (e.g.
Press and hold the "cancel" key
CODE
ALARM
E001
Defective control panel
Remote control communication signal
E002
error
E004
Communication error
Ignition failure error
E101
E105
Pellet probe error
E106
Pellet probe malfunction
E108
Pressure or electrical safety error
E110
Room probe malfunction
E111
Fume probe malfunction
Low pellet level (flashing icon)
A001
Low pellet level
Scheduled maintenance notif ication
A002
(flashing icons)
A004
Low battery
A005
Hall sensor malfunction
----
Stove cleaning
----
Ignition failure error
004778440 - 11/01/2022
ITALIANO ENGLISH
), the appliance will switch off.
E001
to view the alarm code on the display:
DESCRIPTION
DEUTSCH FRANÇAIS
;
POSSIBLE CAUSES
Defective control panel
Defective control panel
Connection cable between board and control
panel interrupted or disconnected.
If it appears during the configuration change,
ignore this error
Insufficient pellets
Pellet quality
Faulty ignition system
Dirty burn pot
Hopper overheating
Pellet probe disconnected or faulty
Sensor(s) connected to T02 (see wiring
diagram)
Defective probe
Overheating problems
Sensor(s) connected to I01 (see wiring
diagram)
Problems on the heating system
Pellet hopper overheating problems
Dirty fume evacuation system
Worn sealing gaskets
Insufficient combustion air
Sensor(s) connected to T01 (see wiring
diagram)
Defective air probe
Overheating problems
Sensor(s) connected to T03 (see wiring
diagram)
Defective flue gas temperature probe
Pellets depleted
Pellet finished
The appliance requires periodic maintenance
by a specialised technician
The back-up battery (mod. CR2032) on the
electronic board is low *
Hall sensor on fumes fan disconnected or faulty
Combustion chamber, burn pot or dirty fume
evacuation.
Detached or blocked pressure detection tubes.
Blocked combustion air intake.
Faulty ignition resistance
Worn gaskets
Incorrect burn pot position
ESPAÑOL
LED
25