Publicidad
Idiomas disponibles
Idiomas disponibles
After checking the message type, it is possible to reset the alarm by pressing the
on/off key
for a few seconds.
If the error code is "E108", manually reset the thermostat on the back of the appli-
ance before resetting the alarm (Fig. 6.1) (to be performed by the technical support
centre).
Before switching on again, check that:
•
the appliance has cooled down;
•
the burn pot is clean and free from ash residue or pellets;
•
the burn pot is correctly positioned in its seat;
•
the fire box and tank doors are firmly closed.
* In the event of a power failure, once the power supply is restored, it will be necessary to set the appliance
again (see paragraph "2 preliminary operations" on page 19).
26
Fig. 6.1
004778440 - 11/01/2022
Publicidad
