3
USING THE APPLIANCE
3.1
Power on
Before each ignition, make sure that the burn pot is completely empty and correctly positioned
in its seat.
To switch on the appliance, press and hold the
The flame icon will start to flash, during the ignition phase until it remains fixed when the stove is on.
Automatic ignition: the appliance is equipped with an automatic device that allows pellet igni-
tion without the use of other traditional ignitors.
Do not manually ignite the appliance if the automatic ignition system is faulty.
During the first ignition of the appliance, unpleasant odours or fumes may be generated due to
the evaporation or drying of certain materials used. This phenomenon will gradually disappear.
During the first ignitions, it is advisable to keep the premises well ventilated.
3.2 Modifying the parameters
It is possible to change the operating parameters of the appliance as indicated above.
The set values will be maintained until the next change, even with the stove off or discon-
nected from the power supply.
3.3 Power off
To switch off the appliance, press and hold the
It is recommended to wait for the appliance to completely cool down before restarting it.
It is recommended to switch off the appliance following the above instructions very carefully
and to avoid doing it by disconnecting the electrical power supply.
3.4 Operation with room thermostat
When the appliance is controlled by an external thermostat (or programmable thermostat), the installer
must have set configuration 2. In this case the appliance shuts down when the external thermostat is
satisfied (open circuit).
The appliance automatically restarts when the temperature drops below the value set on the external
thermostat (closed circuit).
During the first ignition, or if shutdown is prompted directly from the appliance (
latter must be ignited directly from the control panel.
004778440 - 11/01/2022
ITALIANO
ENGLISH
key for a few seconds.
key for a few seconds; the flame icon will go out.
DEUTSCH
FRANÇAIS
ESPAÑOL
key), the
21