Kärcher G 4.10 M Manual De Instrucciones página 14

Operation
Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
Illustrations on Page 2
1 Transport handle
2 Trigger gun
3 Lock trigger gun
4 Key to detach the high pressure hose
from the trigger gun
5 Storage for trigger gun
Storage for high-pressure hose
6 High pressure hose
7 Detergent suction hose (with sieve)
8 Spray lance with pressure regulation
(Vario Power)
9 Thermostat valve
10 High pressure connection
11 Coupling element for water connection
12 Connection for water supply with filter
13 Storage for spray lance
14 Spray lance with Dirtblaster
15 Motor; see operations instructions of
the motor manufacturer
16 Operating instructions for the motor
Special accessories
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Before Startup
Mount loose parts delivered with appliance
prior to start-up.
Illustrations on Page 2
Illustration
 Fasten the transport handle to the
frame.
Align the holes in such a way that the
screws can pass through and then fas-
ten the nuts.
14
Illustration
 Attach the accessories holder.
Illustration
 Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Caution
Always connect the system separator to
the water supply, never directly to the appli-
ance!
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
 Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
 Screw the coupling element to the wa-
ter connection on the appliance.
 Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Drawing in water from open reservoirs
This high-pressure cleaner is suited to work
with the KÄRCHER suction hose with back-
flow valve (Optional accessory, order no.
4.440-238) to draw in surface water, e.g.
from water butts or ponds (see specifica-
tions for max. suction height).
– 6
EN
Water supply