Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm,
and the room is well ventilated with an average room temperature of between 16℃ and 43℃.
Avoid locating your Fridge/Freezer near a heat source, eg, cooker, boiler or radiator. Also avoid
direct sunlight in out-buildings or sun lounges. If you are placing your Fridge/Freezer in an out-
building such as a garage or annex ensure that the Fridge/Freezer is placed above the damp
course, otherwise condensation will occur on the Fridge/Freezer cabinet. Never place the
Fridge/Freezer in a wall recessed or into fitted cabinets or furniture when your Fridge/Freezer is
working, the grille at the back may become hot and the sides warm. It must therefore be installed
so that the back of the Fridge/Freezer has at least 9cm (31/2") of free space and the sides have
2cm(3/4"). Do not drape the Fridge/Freezer with any covering.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be affected and may
cause you Fridge/Freezer to work incorrectly. Once the Fridge/Freezer is placed in its final
location, adjust the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water
and dry completely before replacing in the Fridge/Freezer. The external parts of the
Fridge/Freezer can be cleaned with wax polish.
Before plugging in YOUMUST
Check that you have a socket which is compatible with the plug supplied with the Fridge/Freezer.
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FRIDGE/FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes
before switching back on to allow the coolant fluid to settle.
-38-
Publicidad
