Sony STR-AZ1000ES Manual De Instrucciones página 2

Owner's Record
Record the serial number in the space provided below. Refer to them
whenever you call upon your Sony dealer.
Model No. STR-AZ1000ES
Serial No.
The model and serial numbers are located on the following:
The rear of the unit

Do not install the product in a confined space, such as a bookcase or
built-in cabinet.
To reduce the risk of fire, do not cover the ventilation opening of the unit
with newspapers, tablecloths, curtains, etc. Do not expose the unit to
naked flame sources (for example, lighted candles).
To reduce the risk of fire or electric shock, do not expose this product to
dripping or splashing, and do not place objects filled with liquids, such as
vases, on the product.
The unit is not disconnected from the AC power source (mains) as long as
it is connected to the wall outlet, even if the unit itself has been turned
off.
As the power cord is used to disconnect the unit from the mains, connect
the unit to an easily accessible AC outlet. Should you notice an
abnormality in the unit, disconnect the power cord from the AC outlet
immediately.
2
EN
For Remote Commander
CAUTION
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Do not expose the batteries (battery pack or batteries installed) to
excessive heat, such as sunshine, fire or the like for a long time.
CAUTION
Hot surface
Do not touch
For customers in the U.S.A.
NOTE:
This unit has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
in a residential installation. This unit generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this unit does cause harmful interference to radio
or television reception, which can be determined by turning the unit off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.

Increase the separation between the unit and receiver.

Connect the unit into an outlet on a circuit different from that to which

the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Properly shielded and grounded cables and connectors must be used for
connection to host computers and/or peripherals in order to meet FCC
emission limits.