Sony STR-AZ1000ES Manual De Instrucciones página 29

List of messages after Auto Calibration measurements
Display Explanation
Error 30 Headphones inserted. Remove headphones and re-
measure.
Error 31 SPEAKERS(A/B/A+B/OFF) are off. Re-measure with audio
coming out of the SPEAKERS (A/B/A+B/OFF).
Error 32 No sound was detected from any channel. Is the
measurement microphone damaged? Is it connected to
the CALIBRATION MIC jack on the front of this unit?
Error 34 Front speakers are not installed in the correct position.
Left/right of the microphone and speakers may be
installed in reverse.
* The speaker name in this error message depends on
the detected symptom.
Error 35 Center speaker pattern settings and measurement results
do not match. Check the center speaker pattern and
connection.
* The speaker name in this error message depends on
the detected symptom.
Error 36 3D position could not be measured. Microphone or
microphone stand may be misaligned. Return to the
correct position and try again. If noisy, measure with as
little surrounding noise as possible.
Error 37 • No sound was detected from either the left or right
surround speakers. Is the power for the wireless
speakers that are used as the surround speakers turned
on?
• No sound was detected from either the left or right
surround back speakers. Is the power for the wireless
speakers that are used as the surround back speakers
turned on?
• To output audio from the connected wireless speakers,
update software to the latest version. Press [HOME] on
the remote for this unit and select "Setup" to update.
Error 38 It wasn't possible to measure correctly. Move the speaker
or microphone position a little and try again. If noisy,
measure with as little surrounding noise as possible.
Warning 40 Measurement complete, but it is noisy. It may be possible
to measure again, but it is not possible to measure in all
environments. Measure with as little surrounding noise
as possible.
Display Explanation
Warning 41, The input from the measurement microphone is
Warning 42 excessive. The speaker and microphone may be too close.
Place the speaker and microphone away from each other.
If using this unit as a preamplifier, this message may be
displayed depending on the connected power amplifier,
but it can be used as it is.
Warning 43 The subwoofer distance and phase could not be
measured. Noise may be the cause. Re-measure in a
quiet surrounding environment.
Warning 44 Measurement finished, but the center speaker positional
relationship may be unsuitable. Check the speaker
position referring to "Installing speakers" in the Help
Guide.
* The speaker name in this warning message depends
on the detected symptom.
29
EN