APRILIA eSR2 Manual Del Usuario página 9

Method:
• Take the item out of the packaging
• Open the kickstand and check that the item is stable
• Open the handlebar stem and secure it by closing the lever of the closing mechanism
• Connect the display power cable to the main wiring (if necessary)
• Install the handlebar on the stem (do not crush the cables)
• Tighten the screws on the stem using the wrench supplied
• Adjust the stem closing mechanism* (if necessary)
Model Reference picture
eSR2
eSR2 EVO
Tuareg
eSRZ
CAUTION
Assemble the product correctly. If, during assembly, any factory defects are detected, certain steps are unclear or issues with
assembly or adjustments occur, do not ride the vehicle and contact your dealer or visit www.apriliasmartmovement.com for
technical support.
Do not use accessories and/or additional parts that are not approved by the manufacturer.
Keep children away from plastic items (including packaging materials) and small parts that may result in suffocation.
It is forbidden to modify or transform the item or any its parts in any way, as this may impair efficiency, reduce structural
integrity and cause damage. Remove any sharp edges caused by misuse, breakage or damage to the item. If any factory
defects, unusual noises or faults are detected, do not ride the vehicle and contact your dealer or visit
www.apriliasmartmovement.com for technical support.
* Adjustment
There is a hex screw inside the mechanism.
If the handlebar stem is not very stable after closing, adjust
the screw in the mechanism, by tightening or loosening it as
required to increase the stability of the stem.
There is a hex screw inside the mechanism.
If the handlebar stem is not very stable after closing, adjust
the screw in the mechanism, by tightening or loosening it as
required to increase the stability of the stem.
08