Publicidad
Idiomas disponibles
Idiomas disponibles
EN
EN
EN
NO
NO
DE
DE
3
Unfolding / Folding
NL
NL
Unfolding: Release the lock clamp posi-
tioned at the seat bars (A). Press the seat
SV
SV
bars down and outwards. The side frames
will slide apart. Press down the seat bars
DA
DA
(B). You will hear a clicking sound. The
rollator is now locked in its open position.
Folding: Pull the strap on the seat (C)
FI
FI
and press the side frames together.
Lock the clamp (D) over the seat bars.
Carrying the rollator: The rollator must
IS
IS
not be carried by the seat strap or the
brake cables. Fold the rollator together
as shown on the illustration (E). Carry the
FR
FR
rollator by the seat bars (F) when folded.
IT
IT
4
Handles / Memory function
Height adjusting: Untighten the lock
ES
ES
wheel (A) (approx. 2 turns). Adjust the
handle tube to a suitable height, then pull
it slightly up and down (C) until you hear a
clicking sound. Tighten the lock wheel (A).
Adjust both handles to the same height
by comparing the number scale on each
side. It is recommended that the handles are
set to the same height as your wrists when
your arms are hanging alongside your body.
Memory Function: Decide on the height
of the handles (see number scale). Count
visible holes at the back of the handle
tubes. Unscrew the lock wheel (A). Pull the
tube (B) out of the frame. The fastening
piece (D) will now follow the handle tube.
Move the fastening piece (D) so that the
number of holes above it equals to the
previously counted holes. Fit the red
memory chip (E) on the handle tube in
the first available hole under the fastening
piece (D). Push the handle tube (B) and
fastening piece (D) downwards and into
the side frame (F). Screw the lock wheel (A)
halfway in. Pull the handle (G) up until it
stops, and then tighten the lock wheel (A)
properly. From now on, when the handles
are in the lowest position, they will stop
in the pre-set position when pulled up.
Art. No. User Manual: 105035 – Revision C, 2022-08
5
Brakes
Make sure the brakes are working
before every trip. Each brake lever
(A) works on each of the rear wheels.
Do not drive or push the rollator while
the parking brakes are activated!
Parking brakes: Push both brake
levers (A) downwards until they lock.
Both rear wheels are now locked.
Squeeze both brake levers upwards
to release the parking brakes.
Driving brakes: Pull both brake levers
(B) upwards to reduce speed. Do not use
continuously while the rollator is in motion.
Adjusting / checking: Loosen the nut
(C). Tighten the brake cable (D) with the
adjustment screw (E). Adjust both brake
blocks so the distance to the wheel
surface is approximately 1 mm (F) and
then tighten the nut (C). Make sure the
brakes are not adjusted too tight and
pressing hard into the rubber of the
wheels when the parking brake is on.
Maintaining: Clean the brake block
(F) and the brake spring (G) regularly.
The wheels and brakes can be replaced
if they are worn out or damaged.
6
Seat
The rollator has a safe and convenient
mesh seat, which provides view to the
ground while walking. It can easily be
wiped off with a cloth if needed. The
parking brakes must be activated before
using the seat. Push both brake levers
downwards until they lock (A). Both
rear wheels are now locked. Sit with
your back towards the basket (B).
7
Edge guard / Tilt function
Edge guard: The edge guards (A),
which are in front of the rear wheels
prevent the rear wheels from catch-
ing on corners, door frames etc.
Tilt function: To use the tilt function
use the front of the foot and press down
on the tilt pedal (B), which is beside the
rear wheel. This helps to tilt the rollator
over thresholds, edges etc. Please note:
Be careful when passing kerbs etc.
–
4
–
TOPRO Troja Original
Basket
The basket holds up to 10 kilos (model M
& S) / 5 kilos (model X). It can be removed
and washed gently at up to 60 °C.
Transport
The rollator should be transported in
the folded and locked position (see
section 3 Unfolding / Folding). Ensure
that the lock clamp is on, so that the
rollator cannot unfold unintentionally. Be
careful when loading the rollator into a
vehicle, giving attention to securing it.
Storage
The rollator should be stored in an upright
position. If stored outdoors it must be
under a cover to protect it. Do not leave
the rollator unattended. Do not put heavy
items on top of the rollator during storage.
Cleaning
The rollator can be cleaned using a
damp cloth. In case of mud and grime
accumulation, a cloth with a mild washing
detergent can be used followed by rinsing
with lukewarm water. Do not use high
pressure cleaners and avoid flushing di-
rectly against ball bearings (in wheels and
front forks). Do not use abrasives or steam
wash. Dry the rollator using a soft cloth.
Disinfection
Disinfection must only be carried out by
authorized personnel. Please contact
your local dealer or mobility aid centre.
During disinfection sufficient protective
equipment must be worn, and the
instructions of the disinfectant manu-
facturer must be followed. The surface
of the rollator should be cleaned with a
soft cloth or sponge and an approved
chemical disinfectant containing 70–80
% ethanol. We advise against disinfectant
that contains chlorine or phenol. Do not
use heat disinfection. The manufacturer
cannot be held responsible for any dam-
age or injuries occurred using harmful
disinfectant/measures or disinfection
carried out by unauthorized personnel.
Publicidad
