Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Using the Pulse
1. Verify that the blue light is blinking. This indicates that the blender is turned on.
2. Press and release the "Pulse" button.
3. Release the pulse button to stop.
4. Press the ON/OFF power button to turn the product off.
Use pulse button to crush ice or chop food.
Caring for Your Product
After Use
1. P ress the OFF button and unplug blender. Lift the jar straight up from the
base, remove the lid and empty the jar.
2. I f necessary, use a rubber spatula to scrape foods away from the sides of the jar.
Cleaning
WARNING: Blades are sharp. Handle carefully.
CAREFULLY release the blade from the bottom
of the jar by turning the threaded jar bottom
counterclockwise. The jar lid, filler cap and blade are
dishwasher safe. Use the top rack of the dishwasher for
the jar lid, filler cap, and blade. Place sealing ring into
bottom basket of dishwasher.
You can also wash the parts in warm, soapy water.
Rinse well and dry. Wipe the base with a soft, damp cloth to clean. Never
submerge the blender base in a liquid.
Check the parts as you put them back together.
TIP: Run blender with soapy water for 20-30 seconds at Low or Medium Speed
for cleaning without disassembly. Follow with clean water rinse.
Storing
Reassemble the blender for storage. Leave the lid open a gap so no odors are
retained.
NOTICE: Never put the jar, or any other parts, in a microwave oven. Never store foods
or drinks in the jar.
Servicing
This appliance has no user serviceable parts. Any servicing beyond the cleaning
described in the Cleaning section should be performed by an authorized service
representative only.
If repairs are needed, send your appliance only to an authorized OSTER
Appliance Service Center. Replacement parts are available on www.oster.com or
call 1-800-334-0759.
BLSTMB_16ESM1.indd 10-11
®
10
Blending Tips
Liquids
Put liquids into the jar first, unless the recipe says otherwise. Add more liquid if
ingredients are not blending properly.
Using the Filler Cap
Do not remove the lid while in use. Instead, open the filler cap to add smaller
ingredients.
Ice Crushing
Without Liquid: use pulse button until you achieve desired results.
With Liquid: Add desired amount of ice cubes and water until ice floats. Blend
on High until you achieve desired results then strain off water.
Working with Hot Foods or Liquids
WARNING:
When you work with HOT FOODS, remove the filler cap to
vent steam. Tilt the lid away from you partially covering the opening. Keep
hands and other exposed skin away from the lid opening to prevent
possible burns.
WARNING:
When you work with HOT LIQUIDS, remove the filler cap and
start at a low speed, and then gradually increase to a faster speed. Do not
add liquid over the 4 cup (1L) level. Always keep hands away from steam.
Ingredient Quantities
Use only the amount of food suggested in the recipes. If you want greater
amounts, prepare in batches. Using larger amounts may overload and strain
the motor. You might also get different results from those described.
Frequently Asked Questions
Why doesn't the blender turn on?
• Make sure the base is plugged in an active power receptacle.
• Verify blinking blue light is active after pushing on/off button.
How can I prevent liquids from leaking out?
Check to see that the sealing ring is correctly assembled in between
the blade and the jar.
11
5/18/16 11:40 AM
Publicidad
Capítulos
Tabla de contenido
