Food Processor Accessory (Select Models Only); Assembling And Using Your Food Processor - Oster PRO 1200 Serie Manual Del Usuario

Food Processor Accessory (Select Models Only)

Food Pusher – Use to safely push
ingredients into Slicing/Shredding
Disk.
Cover – The feed tube allows the
addition of ingredients while processing.
Slicing/Shredding Disk – Specially
designed for slicing and shredding.
WARNING: The blade is very
sharp, handle carefully.
Blade Shaft – For use with Slicing/
Shredding Disk.
S Blade – Specially designed for
chopping and mincing. Grasp the
plastic Center Hub when handling the
Blade. CAUTION: The blade is very
sharp. Handle carefully.
Bowl – 5-cup capacity allows for fast
processing of hard-to-chop foods.
Adaptor – Transfers the power
of your Motor Base to the Food
Processor Accessory.
Before Using for the First Time – After unpacking, disassemble unit before using
for the first time.
Wash all parts (except Adaptor) in warm, soapy water.
Rinse and dry immediately.
CAUTION: DO NOT IMMERSE ADAPTOR IN ANY LIQUID.
BLSTMB_16ESM1.indd 12-13
Food Pusher
Cover
Slicing/Shredding
Disk
Plastic Center Hub
Blade Shaft
S Blade
Bowl
Flexible Seal
Adaptor
Green/Frozen
Smoothies Food Chop/Salsa Milkshakes
Motor Base
Low Medium High
Pulse
On / Off Stop
12

Assembling and Using Your Food Processor

1. B efore assembly, make sure Adaptor is operating correctly. Unplug Motor
Base during assembly.
2. P lace Adaptor in bowl and turn counterclockwise to lock.
3. Place Bowl with Adaptor on Motor Base.
To Chop or Mince
4. H old S Blade by the plastic Center Hub and place over post of Bowl.
Caution: Blade is very sharp, handle carefully. Rotate the S Blade to make
certain it is seated on the post as far as it will go. Always place S blade in
Food Processor before adding ingredients.
5. P lace food in Processing Bowl. Food to be processed should always be cut
into 1-inch (2.5 cm) pieces.
6. U sing alignment marks on the lid, place cover on bowl and press down
firmly while turning counterclockwise to lock.
DO NOT OPERATE UNIT UNLESS COMPLETELY ASSEMBLED
7. T urn unit "ON." (Select Pulse, Low, or Med setting on the Motor Base.)
ALWAYS HOLD FOOD PROCESSOR FIRMLY WITH ONE HAND
WHEN STARTING UNIT AND WHEN PROCESSING. Process until
desired results are achieved by running the unit continuously or Fast
Pulsing. Fast Pulsing is the technique used to control the size of the food
being processed with the Food Processor Accessory. Press and release the
Pulse button very quickly. Refer to Processing Chart for proper techniques,
quantities and end results.
NOTE: Only the "Food Chop/Salsa" Pre-Programmed setting is functional
when Food Processor is attached.
To Slice or Shred
8. P lace Blade Shaft over post. Place Slicing/Shredding Disk over Blade Shaft
with the blade of your choice facing up. Caution: Blade is very sharp, handle
carefully.
9. Using alignment marks on the lid, place cover on bowl and press down
firmly while turning counterclockwise to lock.
10. L oad the feed tube with ingredients before turning the food processor "ON".
11. R est the Food Pusher in the feed tube. Turn unit "ON". (Select medium
13
5/18/16 11:40 AM