Casselin CFRPC43 Manual De Instrucciones página 48

MAINTENANCE
BEFORE CARRYING OUT ANY MAINTENANCE WORK, IT IS MANDATORY TO DISCONNECT THE
OVEN PLUG FROM THE ELECTRICAL SUPPLY SOCKET.
CLEANING
Cleaning must be carried out at the end of each use in compliance with hygiene rules and to protect the functionality of
the oven.
Room cleaning:
Turn off the power to the oven by operating the switch on the power panel. Remove the
protection from the conveyor belt joint.
Release the strip from the hook by moving it upwards.
Slide the gasket in question toward the control panel, freeing it from the conveyor belt drive shaft.
Raise the inlet and outlet slide caps to the fully open position. Lift the conveyor belt on both
sides and pull it out from the control side.
Open the side door and, using a pair of gloves, remove the diffusers which are fixed by screws. Clean the metal
surfaces with a sponge dipped in water and a non-abrasive and/or corrosive detergent, then rinse the surfaces
with a sponge dipped in pure water.
Exterior cleaning of the oven (stainless steel surfaces, inspection glass and control panel):
This operation must be carried out with the oven cold.
IT IS RECOMMENDED THAT THE OPERATOR IN CHARGE USE SUITABLE GLOVES AND
CLOTHING TO AVOID BURNS.
FOR CLEANING IT IS FORBIDDEN TO USE: JETS OF WATER, ABRASIVE POWDER, CORROSIVE
SUBSTANCES OR ANY OTHER ELEMENTS LIKELY TO DAMAGE THE COMPONENTS AND
COMPROMISE SAFETY IN GENERAL AND HYGIENE IN PARTICULAR.
MAINTENANCE FREQUENCY
For any extraordinary maintenance, repair and/or replacement, please contact only the authorized dealer from whom
you purchased the device and/or an authorized technician in possession of the technical-professional conditions
required by the regulations in force.
Maintenance, checks and inspections
Mechanical safety devices
Check the condition, the presence of deformations, looseness or removed parts
Control
Check the mechanical parts, the presence of any breakages or deformations, the tightness of the
screws. Check decals and symbols for readability and condition and restore if necessary.
Structural parts
Verification of the tightness of the main bolts (screws, fixing systems, etc.)
Safety Instructions
Check the readability and condition of the safety instructions (labels).
Switchboard
Check the components installed inside the electrical panel. Check the wiring between the
electrical panel and the machine parts.
Connecting cable and plug
Check connection cable and plug. Replace them if necessary.
General overhaul of the machine
Check all components, electrical parts, corrosion, pipes, ...
Frequency
Monthly
Annual
Annual
Annual
Annual
Annual
All 10
years
18