Descargar Imprimir esta página

Look Trail Grip Manual página 8

Ocultar thumbs Ver también para Trail Grip:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EN
CONGRATULATIONS !
With your new LOOK pedals, the adventure can
finally begin. Thank you for choosing our high-tech,
premium quality French product. We hope you enjoy
the ride!
Like the vast majority of LOOK products, they are
identical to the pedals provided to professional
athletes,
and
are
checked
throughout
manufacturing
process
to
ensure
complete
LIFESPAN - USE - REQUIRED INSPECTIONS
All our axles are only approved following extremely
demanding testing, above and beyond the current
standard (ISO 4210). The lifespan of LOOK
components depends on many factors, such
as their use and the cyclist's height and weight.
Impacts, falls, improper use or rough use in general
can compromise the structural integrity of the
components and significantly reduce their lifespan.
Some components are also subject to wear over
time. Have your pedals inspected regularly by an
authorised LOOK retailer to check for cracks,
warping, signs of fatigue or wear. If the inspection
reveals warping, cracks, dents or stress marks,
however slight, immediately replace the component
in question;
satisfaction. Our products meet current European
and international standards.
Please read these instructions fully before use and
follow all the advice given in order to make the most
ofthis high-quality product.
LOOK reserves the right to change the product
the
specifications without prior notice in order to
improve it.
components that have undergone excessive wear
must also be replaced immediately. The frequency
of inspection depends on many factors; consult your
authorised LOOK retailer.
Component must be replaced by an authorised
LOOK dealer.
The list of replaceable components is available from
authorised LOOK retailers.
et respectez-le.
Prenez garde aux dangers de la route et de la circulation.
Prenez connaissance des lois en vigueur dans le pays où vous vous trouvez.
Si vous roulez la nuit, il ne suffit pas de voir mais d'être vu.
Le port d'un vêtement réflecteur est fortement conseillé voire obligatoire dans certai
Le cyclisme est une activité dangereuse par nature et en particulier le VTT. Pour réduire l
blessures graves, veillez à entretenir votre vélo de façon adéquate, et à installer et ajuster co
tous les composants.
Lors de la pratique du cyclisme, portez toujours un casque et prenez connaissance du code
et respectez-le.
Ce que vous trouverez dans votre kit de pads ACTIV GRIP
Prenez garde aux dangers de la route et de la circulation.
READ IN ADVANCE!
Prenez connaissance des lois en vigueur dans le pays où vous vous trouvez.
Si vous roulez la nuit, il ne suffit pas de voir mais d'être vu.
Le port d'un vêtement réflecteur est fortement conseillé voire obligatoire dans certains pays
Cycling
is
an
inherently
dangerous
especially mountain biking. To reduce the risk of
serious injury, be sure to properly maintain your bike
and correctly install and adjust all components.
When cycling, always wear a helmet and follow
Ce que vous trouverez dans votre kit de pads ACTIV GRIP
the rules of the road. Pay attention to the road and
traffic. Stay up to date with all relevant local laws. If
you are cycling at night, you need to be
able to see and be seen.
Wearing reflective garments is highly recommended
or even mandatory in some countries.
For
more
IMPORTANT
INFORMATION,
please consult our website www.lookcycle.com
WARRANTY POLICY section > IMPORTANT
INFORMATION.
INSTALLING THE PEDALS ON THE CRANK ARMS
Product concerned : TRAIL GRIP
Before installing your pedals, ensure the screw threads on the crank arms are BSA standard (9/16x20).
1 - Clean and grease the crank arm threads before
inserting the pedal.
2 - Locate the left pedal, marked with a ring around
the axle (See diagram A).
3 - Facing the left-hand pedal, tighten it clockwise
using an 8mm Allen key, to a torque of 25Nm (figure
B).
À LIRE PRÉALABLEMENT !
activity,
Your ACTIV GRIP pad kit contains :
Pad Activ Grip
Activ Grip Pad
Pad Activ Grip
4 vis
4 - Facing the right-hand pedal, tighten it
counterclockwise using an 8mm Allen key, to a
torque of 25Nm (figure B).
EN
4 Screws
4 vis
Clé de serra
torx T20
T20 Torx wrench
Clé de serrage
torx T20

Publicidad

loading