Publicidad
Idiomas disponibles
Idiomas disponibles
4
OPERATING AND STATUS INDICATORS
4
Operating and status indicators
5
Mounting
6
Electrical installation
6
2
1
3
2
3
4
Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
NOTE
Note the sensor's maximum permissible tightening torque of 0.56 Nm.
Operation in standard I/O mode:
The sensors must be connected in a voltage-free state (U
tion must be observed depending on the connection type:
–
Plug connection: pin assignment
–
Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
The green LED indicator on the top of the sensor lights up.
Operation in IO-Link mode: Connect the device to a suitable IO-Link master and inte‐
grate in the master or control via IODD/function block. The green LED indicator flashes
on the sensor. IODD and function block are available to download from
under the part number.
Explanation of connection terminology used in Tables 1-3:
Potentiometer adjustment (if
1
selected by model configuration) or
LED Indicators
LED indicator green: supply voltage
2
active (with IO Link, flashes when IO
Link Communication is active)
LED indicator yellow: status of
3
received light beam (with IO Link,
when teach mode is active)
Signal strength light bar (if selected
4
by model configuration)
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
V
www.sick.com
8017851.1A15 / 2020-12-14 | SICK
Subject to change without notice
Publicidad
