Silvercrest SHMS 300 C2 Instrucciones De Uso página 10

5) Replace the mixing bowl 8 on the mixer
stand 7.
6) Press the mixer holder release 6
swing the mixer holder 7 back downwards.
7) Place the hand element q on the mixer
holder 7 so that it firmly clicks into place.
8) Push the lid 0 into the rails on the mixer stand 7
so that it sits firmly in place.
NOTE
► If you want to add ingredients during mixing,
open the filling opening 9 on the lid 0 and
add the ingredients. Close the filling opening
9 afterwards to prevent ingredients from
spraying out!
You can use the hand mixer without the mixer
stand 7. We recommend using the hand mixer
without the mixer stand 7 especially for small
amounts of liquid. Otherwise, the mixer cannot
reach all the liquid and it may not be properly mixed.
WARNING! RISK OF INJURY!
► Never use containers made from glass or
other easily breakable materials. These con-
tainers may be damaged and cause injuries.
9) Insert the plug into a mains power socket.
10) To start up the appliance, move the speed
switch 1 to the desired speed setting. You can
choose between 5 speed settings and also
use the Turbo button/ 2 (see section "Speed
levels").
SHMS 300 C2
NOTE
► If ingredients stick to the edge of the mixing
and
bowl 8 and cannot be reached by the
kneading hooks t/whisks r, switch off the
hand mixer.
Remove the lid 0. Use the dough scraper z to
push the stuck ingredients back into the middle
of the mixing bowl 8. Replace the lid 0.
Switch the hand mixer back on.
11) To remove the contents of the bowl, switch off
the hand mixer. Pull the lid 0 off to the side.
NOTE
For safety reasons, the whisks r and knead-
►
ing hooks t can only be released if the
speed switch 1 is set to the position "0".
12) Press the mixer holder release 6
the mixer holder 7 and remove the mixing bowl
8 from the mixer stand 7. You can now re-
move the contents of the bowl.
NOTE
If you want to remove the whisks r or knead-
►
ing hooks t, you must first remove the hand
element q: To do this, press the hand mixer re-
lease 5
Then press the tool-release button w to release
the whisks r or the kneading hooks t.
For safety reasons, the whisks r and knead-
►
ing hooks t can only be released if the
speed switch 1 is set to the position "0".
and remove the hand element q.
GB │ IE
, flip up
│
7 ■