Emos P56211 Manual De Instrucciones página 21

Saturday to Sunday
Temperature change
P1
P2
P3
P4
P5
P6
Screen Illumination
Pressing any button will illuminate the screen for 15 seconds.
Other Technical Settings
Long-press the
Repeatedly pressing the
adjusted using the
Connecting the Thermostat to WiFi (COFI)
Long-press the
Then press and hold the
E2 will appear on the screen and the
Complete the pairing of the thermostat in the mobile app.
See instructions for Connecting the Thermostat to a WiFi Network for Control
via the Mobile App.
Switching Heating/Cooling Mode
Long-press the
Press the button once.
Use the buttons to switch to heating (HEAT) or cooling (COOL) mode.
Confirm with
Setting the Temperature Differential
The temperature differential (hysteresis) is the difference in temperature required
for switching the system on and off. If, for example, you set the temperature in
the heating system to 20 °C and the differential to 0.2 °C, the thermostat activates
heating as soon as room temperature drops to 19.8 °C and switches heating off
when temperature reaches 20.2 °C.
Long-press the
Press the button 2× and use the
differential value (0.2 °C to 2 °C in 0.1 °C increments).
Confirm with
Ambient Temperature Calibration (CAL)
The temperature sensor in the thermostat is calibrated from production, but
additional calibration can be done to optimise the thermostat further, for instance
by comparing the measured room temperature with a reference thermometer.
Long-press the
button for about 5 seconds.
button selects from the functions below, values are
buttons.
button for about 5 seconds.
button for 3 seconds.
button for about 5 seconds.
.
button for about 5 seconds.
.
button for about 5 seconds.
Time
7:30
9:30
11:30
13:30
16:30
22:30
icon will be flashing.
buttons to set the temperature
21
Temperature
20 °C
20 °C
20 °C
20 °C
20 °C
15 °C