Beem FRESH-AROMA-PERFECT Manual De Instrucciones página 30

EN
1. Prepare the coffee machine for making coffee with coffee powder or coffee beans and set
your desired number of cups, coffee strength etc.
2. Press the button
3. Start the brewing process (see the "Preparation" chapter). The hotplate remains switched
on after the end of the brewing process.
4. The keep-hot function switches off automatically after 40 minutes. If you want to stop the
keep-hot function prematurely, press the button
chosen preparation type).
If the thermal jug is used, care must be taken to ensure that the keep-hot function is
switched off. Press the
Please Note! As the design of the device means that the hot water lines run under
the hotplate, the thermal jug gets hot during the brewing process despite the keep-hot
function being switched off. This is normal and does not represent a defect.
Drip Stop
The device has a drip stop which prevents water from dripping out of the filter when the coffee
jug (6) has been removed from the device.
When the device is in operation, the filter compartment (5) must be closed and a coffee jug
with a lid placed on it must be placed beneath the filter compartment. The lid of the coffee jug
pushes the drip stop upwards and the coffee can flow from the filter through the lid into the
coffee jug.
During the brewing process, the jug must not be removed from the device for longer
than 30 seconds as otherwise the filter could overflow.
Preparation
PLEASE NOTE!
• Do not operate the device without water or with less water than is required to reach
the 2 Cups mark. If this does happen, the device switches off automatically. In this case,
allow the device to cool down before water is poured in and the device is used again.
• Never use the device without a suitable jug below the coffee outlet.
Making Coffee with Coffee Beans
1. Prepare the coffee machine, pour in coffee beans and water, set the grinding fineness and
insert the permanent filter (see the "Handling and Operation" chapter).
2. Set the number of cups and coffee strength you want (see the "Handling and Operation"
chapter – "Setting the Number of Cups" and "Setting the Coffee Strength").
before the brewing process is started.
button if necessary, and
appears on the display (19).
(18) or (20) (depending on the
will go out on the display.
28