STAMOS S-LS-115 Manual De Instrucciones página 25

3. Overcurrent protection (OCP)
To switch on the overcurrent protection press the OCP button (5). An illuminated OCP
indicator (15) indicates that the protection is switched on. To switch off the
overvoltage protection briefly press the OCP button again (5). The indicator will go off.
- To check the OCP values or make changes to the values, press and hold the OCP
button (5) for 3 seconds. Current OCP values will be displayed. Turn the knob (7) to
change OCP values . To exit the configuration setting function, press and hold the OCP
button (5) again for 3 seconds.
CAUTION! If protection is switched on and the voltage values exceed the configured
maximum levels, the output will be cut off.
4. Overvoltage protection (OVP)
To switch on the overvoltage protection press the OVP button (4). An illuminated OVP
indicator (14) indicates that the protection is switched on. To switch off the
overvoltage protection briefly press the OVP button again (4). The indicator will go off.
- to check the OVP values or make changes to the values, press and hold the OVP
button (4) for 3 seconds. Current OVP values will be displayed. Turn the knob (7) to
change OVP values . To exit the configuration setting function, press and hold the OVP
button (4) again for 3 seconds.
CAUTION! If protection is switched on and the voltage values exceed the configured
maximum levels, the output will be cut off.
5. DC current indicator
Illuminated C.V indicator (17) indicates DC amperage.
6. DC voltage indicator
Illuminated C.V indicator (17) indicates DC voltage.
7. Output voltage indicator
Illuminated OUT indicator (18) indicates the output voltage.
8. Control panel lock
To lock the front panel, press the LOCK button(6), pressing and holding the button
again for 2 seconds will unlock the panel.
9. Audible signal
The audio signal is switched on by default . To switch off the audio signal, press and
hold the OCP button (5) for 2 seconds. Press and hold the button again to switch on
the sound.