Publicidad
Idiomas disponibles
Idiomas disponibles
16. DC current mode indicator
17. DC voltage mode indicator
18. Output voltage indicator
19. Quick settings recall buttons
20. Ventilation holes
21. Power socket
22. USB port (only
23. RS232 port (only
3.2.
POSITIONING OF THE UNIT
The unit should be placed on a work surface that is at least equal in size to the unit's
size. For optimal operation of the device, the work surface should be flat, dry, heat
resistant and should be placed at the proper height. Ensure that the power supply to
the unit corresponds to that specified on the identification plate!
3.3.
1. Startup and configuration of output parameters
a) Connect the power cord to the power socket (22) on the rear panel of the
unit. Connect the power cord plug to a power source.
b) Switch on the unit by pressing the POWER button (1).
c)
Set the output parameters:
- use the voltage/amperage selection button (9) to select the value to be set
on the display (13)
- to change the voltage value, use the adjustment buttons (8) to set the
position of the cursor on the display, turn the knob to set the value of the
flashing digit,
d) After completing the settings press the output activation ON/OFF button (2).
e) To turn off the device press POWER button (1) again.
2. Recalling settings saved in memory
- to recall the already stored settings, press one of the four buttons M1-4 (3), to recall
the M5 setting, press M4 and turn the knob (7) to switch to M5, the display will show
the stored values and the LED on the panel will light up indicating the number of the
recalled setting (19),
- to save the parameters in the corresponding cache memory, turn on the selected
settings as described above and set the desired values (as described in section 3.3.
subsection 1), then wait until the value stops flashing, the settings will be saved
automatically.
S-LS-116)
S-LS-116)
Preparation for operation
Working with the unit
Publicidad
