STAMOS S-LS-115 Manual De Instrucciones página 26

10. Remote control
a) Switching on remote control
- install software from the CD disk
- configure COM port of the computer, apply the following settings:
Baud rate: 9600
Parity bit None
Data bit 8
Stop bit 1
Data flow control: None
- Connect power supply to the computer via USB or RS232 port. The device
should automatically connect to the computer, and device's control panel
will become inactive. Parameters will be editable only on the computer.
b) RS232 interface definition
S-LS-116
3.4.
Cleaning and maintenance
a) Pull the mains plug before each cleaning, adjustment, replacement of
accessories and also when the unit is not in use.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
d) Do not spray the unit with a stream of water or immerse it in water.
e) Clean the ventilation openings with a brush and compressed air.
f) To ensure fire protection, replace the fuse only with the specified type and
class.
PC