Robur 8147S Instrucciones página 15

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PROHIBITIONS
Do not:
• Use the accessory if all the instructions in the general warnings have not been observed.
• Use the accessory if the data plate and/or markings are missing and/or illegible.
• Use the accessory if it and its component parts are not in good condition.
• Use the accessory if the drawbar eye is not installed correctly.
• Use the accessory if the safety devices are not operating correctly or damaged.
• Fix the accessory in place other than as described in this user manual.
• Use the accessory for purposes or in configurations other than those described in this user manual.
• Motorise the accessory or operate it other than as instructed.
• Permit more than one person to operate the accessory.
• Clean the accessory with high pressure equipment and/or aggressive chemical substances (such as acids and chlorinated products).
• Use the accessory in excess of the WLL value.
• Use the accessory in ambient temperatures outside the -10°C - 50°C range.
• Use the accessory to lift a load when the wind speed renders it unstable.
• Use the accessory to lift or move persons.
• Use the accessory in explosive or corrosive atmospheres.
• Use the accessory in conditions which could lead to excessive overheating.
• Attempt to lift a load subject to restraints.
• Use the drive chain of the accessory to lift, drag or anchor.
• Use the accessory or load cable as an electric mass or conductor.
• Force the movement of the carriage if it has reached the limit switch of the beam or if the sideways movement is obstructed in any way.
• Pull a load to be lifted in the lateral direction.
• Allow the carriage to oscillate beneath the accessory.
• Stand or move beneath the load.
• Work on the accessory without first removing the load.
We declare upon our sole responsibility that the product described conforms with all the relevant provisions of the 2006/42/CE
Machinery Directive and subsequent amendments, and with the following standards:
• EN 13157
The Technical Folder may be obtained from:
BETA UTENSILI S.P.A. – DIVISIONE ROBUR
Zona Industriale - C.da San Nicola,
67039, SULMONA (AQ)
ITALY
8147S_8147C.indd 15 8147S_8147C.indd 15
CONFORMITY DECLARATION

EN I
15
28/02/22 17:37 28/02/22 17:37