Segway Audi G30D II Manual Del Usuario página 6

EN
Charge the KickScooter for three seconds to activate the battery before the
first use. Otherwise, your KickScooter cannot be powered on.
6 Charging
Charging step tips
Charge port
Do not charge the battery if the charge port or power cord is wet.
Do not charge or use the battery if it is damaged or you can see
traces of water.
Close the charge port cover when not charging the battery.
+
≤30%
≈10
When charging, the speedometer icon indicates the current battery level when the KickScooter is powered
on. When the scooter is not powered on for about ten consecutive days and its battery level is under 30%,
the battery will enter sleep mode. If this happens, your scooter cannot be powered on. Please charge it for
three seconds to activate the battery.
7 Learning to Ride
Wear an approved helmet and other protective
gear to minimise any possible injury.
08
Open the charge
Insert the
port cover. charge plug.
WARNING
=
1. Power on the KickScooter and check
the power level indicator. Charge the
KickScooter if the battery level is low.
Close the charge
port cover when
finished.
2. Stand on the footrest with one foot
and push off with another foot to
start gliding.
4. Slow down by releasing the throttle; and
brake by squeezing the brake lever.
WARNING
When hard braking, you risk serious injury due to loss of traction and falling.
Maintain a moderate speed and look out for potential hazards.
3. Put your other foot on the footrest to keep
both feet stable. Press the throttle on the
right hand to speed up when you are
balanced.
Note: For your safety, the motor will not
engage until the KickScooter reaches
1.9 mph (3 km/h).
5. To turn, shift your body weight and
turn the handle slightly.
EN
09