Publicidad
Idiomas disponibles
Idiomas disponibles
4 Harness Attachment
4.3
Attach V-SHOCK EDGE PFLs to Harness Using V-SHOCK EDGE Pin Connector
The V-SHOCK EDGE PFL pin connector allows connection to a full body harness just below the rear D-ring or through the
PFL tunnel.
1. If harness has PFL tunnel—use PFL tunnel as
connection point.
If harness does not have PFL tunnel—Lift D-ring on
harness and pull straps through dorsal pad until
V-SHOCK EDGE pin connector can feed between
webbing straps and dorsal pad.
3. With the button on the pin depressed, feed the pin
through PFL tunnel or behind both straps on harness to
the left side of the bracket.
a. Release the button on the pin and pull on the end
of the pin slightly to ensure it has locked into
place.
11
2. Press the button on right side of the pin and press
the button on the top of the right side of the bracket.
Pull the pin to the right to open the pin connector.
4. If harness has PFL tunnel— Installation complete.
If harness does not have PFL tunnel— Pull harness
straps back through dorsal pad to eliminate slack in
webbing.
V-SHOCK & V-SHOCK EDGE PFL
US
Publicidad
