MSA V-SHOCK Manual De Instrucciones página 19

6 Fall Clearances
6.4 V-SHOCK EDGE Tieback Fall Clearance Charts
6 ft V-SHOCK EGDE Tieback PFL: 6 ft / 1.8 m Lifeline + 2 ft / 0.6 m (Total Length: 8 ft / 2.4 m) *
10 ft V-SHOCK EGDE Tieback PFL:10 ft / 3 m Lifeline + 2 ft / 0.6 m (Total Length: 12 ft / 3.6 m) *
* Tieback section = 3 ft / 0.9 m
V-SHOCK EDGE Tieback Single PFL V-SHOCK EDGE Tieback Twin PFL
Product: V-SHOCK EDGE Tieback PFL
Use: Leading edge applications
Capacity: ≤ 310 lbs (141 kg)
(A) Clearance values shown are based on 2 ft (0.6 m)
anchorage setback from the leading edge. Anchorage
connector may be used at setback distance of 2 ft (0.6
m) from the leading edge or as far back as required.
For every 1 ft (0.3 m) the anchorage location is set
back from the initial 2 ft (0.6 m) setback, the user can
subtract 0.5 ft (0.15 m) from the clearance provided in
the chart based on the user's offset distance.
If the V-SHOCK EDGE Tieback PFL is anchored
around a structural member that has been suitably
identified by a qualified person, the initial setback of 2
ft (0.6 m) may be reduced by an amount equal to the
circumference of the object, up to 2 ft (0.6 m).
NOTE: Clearance chart anchorage location for
illustrative purposes only.
ILLUSTRATION NOT TO SCALE
WARNING!
* In leading edge applications with 0 ft (0 m) setback, ensure that setup does not allow snaphook to contact leading edge
in the event of a fall.
Failure to follow this warning can result in serious personal injury or death.
US V-SHOCK & V-SHOCK EDGE PFL 20